Baileigh Double Pinch Roll Bender R-H85E

Baileigh Double Pinch Roll Bender R-H85EThe R H85E double pinch roll bender from Baileigh Industrial is an economical way to get into the world of double pitch roll bending. But with its capacity of 3" Schedule 40 pipe and 3 3 8" x 3 3 8" x 1 4" angle iron, it does not skimp on power. To achieve this capacity the R H85E roll bender uses an industrial grade hydraulic transmission that drives all three rolls and only used 220 volt three phase power. The R H85E is considered a double pinch

The R-H85E double pinch roll bender from Baileigh Industrial is an economical way to get into the world of double pitch roll bending. But with its capacity of 3" Schedule 40 pipe and 3-3/8" x 3-3/8" x 1/4" angle iron, it does not skimp on power. To achieve this capacity the R-H85E roll bender uses an industrial grade hydraulic transmission that drives all three rolls and only used 220 volt three phase power.

The R-H85E is considered a double pinch roll bender since the top roll is fixed and the two bottom rolls are on independent hydraulic cylinders with encoders that communicate to the DRO programmers for exact positioning of each roll. The double pinch design helps minimize those money wasting pieces of straight that are commonly found at the start and finish of the bend by allowing the operator to pre and post bend the material.

• 3" schedule 40 pipe
• Economical
• Three driven rolls
• Double pinch
• Overload protected
• Hydraulic guide
• Manually adjustable lateral angle guides
• Includes hardened segmented rolls
• Vertical and horizontal bending
• Foot pedal controlled
• Digital readout with programmable stops
• Many optional toolingsets available