Pocket Operator Double Rack includes Cable - Angled Stand holds any TWO Teenage Engineering PO models - INCLUDES 6" Connector Cable!

Pocket Operator Double Rack includes Cable - Angled Stand holds any TWO Teenage Engineering PO models - INCLUDES 6" Connector Cable!This desktop stand was custom made for TWO Pocket Operator (PO) Synthesizer Devices from Teenage Engineering. Each stand holds TWO POs and fits all PO models with or without the silicon Pro Case. It holds them at the perfect angle to make it easy to press the buttons, perform and see the screen. One 6 inch connector audio cable is INCLUDED! to make sure your setup works :) This rack can be ordered in wood or acrylic. See the options when purchasing to

This desktop stand was custom made for TWO Pocket Operator (PO) Synthesizer Devices from Teenage Engineering. Each stand holds TWO POs - and fits all PO models with or without the silicon Pro-Case. It holds them at the perfect angle to make it easy to press the buttons, perform and see the screen. One 6-inch connector audio cable is INCLUDED! - to make sure your setup works :)

This rack can be ordered in wood or acrylic.  See the options when purchasing to select the finish you like best!

It comes un-assembled and can be assembled in less than a minute - which makes it easy to un-assemble again to take on trips or gigs - it almost fits in your pocket when un-assembled. When assembled, it measures: 7.25 inches wide - 4.75 inches deep - 2.5 inches high in the back - 1.25 inches high in the front. It has pass-through holes on the sides, back and front for wire management, and has cut-outs for the input and output plugs. The PO Stand fits Pocket Operators with OR without the Official Teenage Engineering Silicon Pro-Cases - as shown in the picture.

NOTE - You can NOT fit two POs connected with the straight connector wires - you MUST HAVE 90 degree connector wires as shown - WHICH IS WHY WE INCLUDE ONE :)

If you prefer the straight wires, or just want more flexibility in positioning the two POs, use TWO single stands as an alternative (listing here: https://www.etsy.com/listing/855327264/pocket-operator-stand-single-angled-for).

The Pocket Operator drops easily into place on top of the stand, with no other clips or screws or connectors. The Teenage Engineering Logo shown in the pictures is a registered trademark of Teenage Engineering. Note: the pocket operators shown in the pictures are NOT included ;)