Heavy Hitter V1 Talaria Skid Plate

Heavy Hitter V1 Talaria Skid PlateIMPORTANT NOTICE: V2 will be released 12 1 2025 for Pre Order. This V1 will be discontinued since it will not work with all "new" aftermarket motors more details below. Meet the last skid plate your bike will ever need. With 7075 T6 billet aluminum side supports and replaceable bash plates, the GritShift Heavy Hitter Skid Plate withstands a whopping 6,000 lbs of force the end all protection solution for your Talaria E Moto. Your motor sits at the very

IMPORTANT NOTICE: V2 will be released 12/1/2025 for Pre-Order. This V1 will be discontinued since it will not work with all "new" aftermarket motors — more details below.

Meet the last skid plate your bike will ever need. With 7075 T6 billet aluminum side supports and replaceable bash plates, the GritShift Heavy Hitter Skid Plate withstands a whopping 6,000 lbs of force — the end-all protection solution for your Talaria E-Moto.

Your motor sits at the very bottom of the frame, right where rocks, roots, and logs strike. The Heavy Hitter has the perfect strike angle for obstacles, a thick 10mm aluminum bash plate, an extended tail section, and strategically placed venting for top-notch motor protection on-road and off. Damage it? The replaceable bash plate swaps out in minutes.

Features

• The most robust, over-engineered skid plate on the market for e-bikes
• 7075 T6 billet aluminum with a 10mm bash plate tested to withstand over 6,000 pounds of force
• Strategic ventilation slats keep your motor cool while ensuring maximum protection
• Extended tail section for enhanced protection from perpendicular strikes
• Each section is easily removable for routine maintenance
• Replaceable bash plate can be exchanged in minutes
• Lifetime warranty (side rails only): if the side rails ever bend, they'll be replaced for FREE (not applicable to bash plates; replacements available upon request)

Fitment

• Talaria Sting MX3 / MX4 / MX5

Note: Will not fit EBMX XTA Core Motor. Torp controller covers require slight modification to fit. Use blue medium threadlocker on all hardware during installation; mounting bolts are T20 Torx and the recommended torque is 2.6 Nm / 1.92 ft-lb / 23 in-lb — barely hand-tight, but with threadlocker correctly applied it holds securely and stays removable.

Guides