Libec Tripod case compatible with RS-250D, RS-350D, HS-150, HS-250 and HS-350

The factory-designated tripod cases engineered to fit the Libec RS-250D, RS-350D, HS-150, HS-250, and HS-350 configurations vary depending on whether your system uses standard lightweight aluminum or quick-locking leg setups. Because these 75mm systems share a common compact folded height, Libec matches them to two specific cases:

1. The Standard Lightweight Option: Libec RC-30

The RC-30 is the official carrying case included out-of-the-box with the standard floor-spreader versions of the RS-250D, RS-350D, HS-150, and HS-250 kits (which typically use the RT30B or RT30RB leg sets).

• Dual-Use Mat Design: The standout feature of the RC-30 is that its zipper track allows the case to open completely wide and lay 100% flat on the ground. Crews frequently use it as an impromptu gear floor mat to protect lenses, camera plates, or batteries from mud, dust, and damp grass on location.

• Streamlined Portability: It is a non-padded, lightweight vinyl/nylon bag optimized for fast-moving crews, single-operator ENG shoots, or daily local transport where minimizing bulk and transport weight is the priority.

• Internal Storage: Built with a small interior sleeve compartment designed to hold unmounted pan handles (like the PH-6B) and camera plates so they don't scratch the tripod tubes during transit.

2. The Premium Padded Option: Libec RC-40 / RC-50

For the HS-350 system (which utilizes the longer/bulkier QL40B legs) and any of the "M" (Mid-Level Spreader) configurations in these series, Libec upgrades the bundle to a heavier-duty casing.

• Full Foam Armor: Unlike the soft RC-30, these cases feature rigid multi-layered foam walls. This provides significant impact absorption to protect the continuous counterbalance dials and illuminated bubble modules of the H15/H25/H35 and RH series heads from truck transport or drops.

• Hardened Base Support: Equipped with structural plastic skid plates and rubber feet on the bottom end, allowing the bag to stand vertically or survive rough handling on abrasive concrete surfaces without tearing.

Quick Compatibility Guide:

💡 Transit Safety Note: If you are packing the soft-shelled RC-30 for transport in a crowded production van or shipping case, always collapse your telescopic pan bar fully and rotate the handle down between two of the tripod legs. This uses the structural aluminum legs as a protective cage to shield the rosette clamp and fluid head pan-tilt levers from crushing side impacts.