Pay in installments of $6.11 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 18 - Jul 23
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Red Line Synthetic Gear Oil 58304Red Line Gear Oils are designed to provide excellent low temperature characteristics and improved gear protection at higher temperatures. Red Line Gear Oils will reduce differential temperatures 10 to 70 Degree Fahrenheit. Efficiency improvements between 1 to 5 Percent are typical. The synthetic base stocks used have tremendous thermal stability and provide the best film strength available. The unique combination of base stocks and additives allow Red
Red Line Gear Oils are designed to provide excellent low temperature characteristics and improved gear protection at higher temperatures. Red Line Gear Oils will reduce differential temperatures 10 to 70 Degree Fahrenheit. Efficiency improvements between 1 to 5 Percent are typical. The synthetic base stocks used have tremendous thermal stability and provide the best film strength available. The unique combination of base stocks and additives allow Red Line gear oils to carry higher loads compared to petroleum lubricants. The stability of these products allow them to be used for extended periods. Red Line 75W90 Gear Oil provides excellent protection in nearly all differentials, conventional and limited slip, in both racing and street use. 75W90NS and 75W140NS can be used in certain limited slip units in racing to lock up the differential. 80W140 should be used in commercial hauling, problem limited slip units, racing applications which see tremendous torque at low speeds, and where noise deadening is desired. Lightweight or SuperLight can be used to obtain maximum power transfer in racing differentials which do not see extremely high temperatures. If "chattering" occurs with any of these lubricants, Red Line Limited Slip Friction Modifier can be used to eliminate the stick/slip action and reduce the noise. This additive should not be necessary in the 75W90, 75W140 or the 80W140 Gear Oils, since they already contain this additive, but in some units more is required. Too much friction modifier can reduce the lockup in limited slip units, so it should only be used if needed.
Viscosity Grade: SAE 75W-90 NS
Use: Manual Transmissions And Transducers
Type: Synthetic
API Rating: GL 5+
Unit Size: 1 Quart
Unit Type: Bottle
Features
- Appropriate Coefficient Of Friction For Most Manual Transmission Synchronizers
- Red Line Offers Lubricants To Pinpoint Nearly Every Transmission Application
- Excellent Gear And Synchro Protection, Balanced Slipperiness For Easier Shifting In Cold Climates
- Excellent For High And Low Mile Transmissions
- Compatible With Petroleum's And Other Synthetics
- Improved Copper Corrosion Protection To Prolong Synchro Life
- Helps With Lockup On Weak Limited Slip Differentials Compatible With Red Line Limited Slip Friction Modifier For Tuning Slippage
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.8 ★★★★★
Based on 27 reviews
Sort
Product Reviews
★★★★★ 5
Easy to set up & works great
Style: Single Arm, Size: 13"-34"
It was super easy to get set up, came with all the hardware ypu need to install multiple ways. Holds my monitor securely and is still easy to move around. The adjustments are easy to access and have plenty of variation. Great purchase, such a reasonable price.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 16, 2026
★★★★★ 5
I love it!!
Style: Dual Arms, Size: 17"-33"
I love this product. I do a lot of gaming and you tube watching. At the same time a lot. With this I keep my desktop clear so I can have my notebooks there and can still have both my monitors up and running. Another plus is if I decide to sit on the couch and play the console I can turn the screen a full 180 degrees so I can setup you tube and play games on the T.V. using the console.
The product itself feels to be of decent quality. It is not all plastic. The clamp is nice and strong.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 24, 2026
★★★★★ 3
Gets the job done. Just barely.
Style: Dual Arms, Size: 17"-33"
It holds up my monitor, but just barely, and without any confidence or finesse.
I had to move on from my previous arm mounts, the HUANUO. Those claimed to hold up to a 30 inch monitor and support 20 pounds. When I upgraded to a Samsung Odyssey Neo G8, it could no longer perform its duties. The gas shock was up to task, but the final adjustment piece that tilts it up or down was a hard down.
Queue this piece of hardware! 22 pounds is more than 20, and 32 is more than 30. This time I'm not even technically out of spec. The clamping force seems more than adequate to hold this to my desk. I will, at this point, basically walk you through how I feel about this mount, based on the order of installation instructions.
The way it goes together means that you will have to pull your desk out to maneuver the clamp in place before snugging it back up to the wall, a point in the HUANO's favor since it had a clever leveraging mechanism that lets you hang it with your desk still against the wall.
The way cords route through the arms close to the base means that you have to route them before you put the swivel arm on the base. This is because it has a screw at the front and back to secure the cover, and the angle/height are such that you cannot fit a screwdriver into the bottom one after you mount it. While not impossible to do with it installed, it would involve a right-angle screwdriver. They provide one of those, but the screwdriver bit of it is on the long shaft, and you would need it on the short shaft to get to that screw.
The way the swivel arms mount on the base is less than ideal as well. The arm slips onto a robust metal hub, and you tighten a screw that pushes against a plastic tab that makes it harder or easier to move. The location for this screw faces the wall. So you must turn the arm at an extreme angle to make it tighter or looser. Not a big deal, but noticeable.
Top arms go on smoothly, cable routing is simple and easy. No complaints about this section.
Mounting the monitor. The instructions are to mount the plate to the monitor, and then slide the plate onto the holder and secure it with the screw. I did this for neither of my monitors, although I tried it for my second. My big monitor went smoothly by mounting the bracket ahead of time and just forcing the arm down into position while my monitor rested on my desk. I tried this for my second bracket, but it was much harder to do with the monitor in a vertical orientation. So then I tried to do it the way the instructions wanted. I would have been able to do so, but my monitor has the mounting location set into the back of the monitor. This means that you can't mount it flush and then slide it on because you don't have clearance. So I tried to use the spacers. The spacers aren't spacious enough and the screws bottomed before snugging. While I'm not saying that solution wouldn't have technically worked, I instead reverted back to mounting the bracket first. This time I laid my monitor flat on the desk, reduced the tension in the shock greatly, and placed it into position that way.
At the end when it's complete and setup? It works. It will hold the G8. But just barely. The G8 uses an adapter to go from the monitor mounting points to VESA 100. This adapter sticks out quite a bit from the monitor, which means the weight is further away from the mounting point. Getting the tilt adjustment to hold involved a bigger allen wrench and cranking it further than it seems like it was meant to go. It groaned, but it held. It wants to dip if you mess with it, so I crank it again. Will it one day totally fail on me and point my monitor at my desk? Maybe. But it works on day 1, so that's a start.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 29, 2024
★★★★★ 5
Holds Backpack Straps Together
Size: 6inches-60PCS
Good quantity for its price. It’s a good quality and durable. I use it to hold my Loungefly backpack straps that I hang on my wall and it does its job perfectly. It’s reusable too.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 22, 2026
★★★★★ 5
Perfect for small normal cables lying around.
Size: 6inches-200PCS
Cable ties to organize my random cable is what I needed in my life. The quality is solid and it's easy to use and adjust. They hold well without slipping and the size is perfect for use with normal cables. its about 6 inches long so its gives you a little less than 3inch radius considering they way it is suppose to loop. I think realistically, its more like 2 inch radius. It is versatile and can be reused considering its velcro.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 6, 2026