Pay in installments of $10.19 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 31 - Aug 5
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Happymodel SuperBee F4 Lite AIO Whoop Flight ControllerSince the solder joints of the flight controller are small and compact, please be careful when soldering. Any problems caused by soldering will void warranty, no replacement can be provided free of charge. But it can still be sent back for repair. Setup Notes This flight controller setup at the factory for the Mobula6 HDZERO, the original default device for OSD is "MSP" If you plan to use this FC for for analog FPV camera, you need to activate the OSD
Since the solder joints of the flight controller are small and compact, please be careful when soldering. Any problems caused by soldering will void warranty, no replacement can be provided free of charge. But it can still be sent back for repair.
Setup Notes
This flight controller setup at the factory for the Mobula6 HDZERO, the original default device for OSD is "MSP" If you plan to use this FC for for analog FPV camera, you need to activate the OSD :
First connect to betaflight configurator , and type the CLI command, and enter "set osd_displayport_device = MAX7456", then reconnect betaflight ,upload osd font. The update font option is important that many users forget about!
Also depending on supply you may receive a different Gyro, refer to the diagram below to see what orientation to use.
Specification
|
Flight controller
SuperbeeF4 Lite ELRS/FRSKY |
SPI ELRS version Firmware target: CrazybeeF4SX1280
SPI FRSKY version Firmware target: CrazybeeF4FR MCU:STM32F411CEU6 (100MHz, 512K FLASH) Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection) Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in SPI Frsky/ExpressLRS receiver Built-in 5V 1A BEC Built-in voltage detection |
| Onboard 4in1 ESC |
MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HV (2.8v~4.35v) Currents: 5A continuous peak 6A (5 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_8.HEX Default protocol: DSHOT150/DSHOT300/DSHOT600 |
| Onboard SPI ExpressLRS 2.4GHz Receiver |
Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
RF Frequency: 2.4GHzAntenna plug: IPEX Telemetry output Power: <12dBm Receiver protocol: SPI ExpressLRS Could bind with ELRS V2.0 firmware TX module |
| Onboard Frsky SPI D8 /D16 2.4GHz Receiver |
SPI BUS receiver Frsky D8/D16 compatible
Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)Channels: 8ch or 16ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol |
Included
- 1 x Superbee F4 Lite AIO flight controller ELRS / FRSKY version for 1S tiny whoop drone
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.2 ★★★★★
Based on 27 reviews
Sort
Product Reviews
★★★★★ 3
Nice shirt but too short
I'm 6', 175 with a bit of a longer torso. That makes me a slim build bordering on tall/slim. The material seems on par with similar offerings from Nike and the shirt looks and fits quite well (I like the slim tailor) but it was not long enough to tuck in as a medium (right at my belt line). I tried a large which is getting a little big around and it was still too short. XL was ridiculously wide on me and still not long enough.
Bottom line is that Amazon needs to offer this shirt in a slim/TALL with about 3" of additional length. There would be a whole lot of buyers. I'll have to continue to go to the specialty shops in search of MT and LT sizes.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 31, 2021
★★★★★ 5
Nice for the price
I am 6’4” and 195 lbs so I need a large size for most shirts. I need it for the length, but not the width, so shirts this size tend to bow out at the back and make me feel a bit like I am wearing a tent. I prefer polos made of a very thin, breathable and moisture wicking fabric. A decent looking shirt you can wear on hot and humid days without any undershirt and stay comfortable. Old Navy makes a fantastic version, very similar to the ridiculously priced Under Armor version, and I was hopeful that this Amazon version would compare. It does, but has a few drawbacks. If this sounds like you, keep reading. If not, thanks for getting this far.
I’ll keep this brief with a list of pros and cons below. Suffice it to say, I like the polo enough not to return it, but it is still a step below some of the shirts produced by other outlets.
Cons:
1. It is far from wrinkle free, though I’m not sure it is even touted to be. It does tell me, though, that this fabric won’t be as soft as I prefer.
2. The color is a little darker (I got the coral) than it seemed in the picture, but not terribly so.
3. The “slim fit” is what drew me in and while it better than most, the back still bows out a bit
4. The fabric is clearly moisture wicking, but not the light fluffy kind. I know I’m starting to sound like a snob, but if you know what I mean, you know what I mean. Sometimes a shirt feels heavy when you sweat in it. The idea of the moisture wicking fabric is to pull that sweat away as fast as you produce it to aid in the evaporative cooling taking place on your body. This shirt doesn’t feel heavy, but I’m not sure how long it will stay that way on a really hot and humid day.
Pros:
1. Price. For $15, I can become blissfully ignorant to the cons listed above.
2. Fit. It isn’t perfect (Yes, I know this is listed as a con too), but if you have a tall, lanky body type like me, a large will fit you better than your average polo. After a trip or two through the dryer, probably even more so.
3. Convenience. Now that I know this is a good fit for me, I can try all the different colors I want from the comfort of wherever I choose to be with my phone.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 30, 2020
★★★★★ 5
2nd shirt purchased for golf team priced right slim fit comfortable
We needed golf shirts for being on the school golf team. Brand name golf clothing is extremely expensive and not worth it for a growing slim teen so our first purchase was this shirt in a different color. This is the 2nd shirt we've purchased after loving the first one. Good quality, value, and comfort. Easy wash and dry. Can be washed and thrown on a hanger to dry. No shrinkage. Perfect fit. This is a men's small that fits great on a person ~ 5' 10". The material is thin and does not hinder golf swings. Love that this shirt, and most Amazon clothing, has no brand markings. Wise marketing that Amazon's clothing is NOT labeled.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 13, 2021
★★★★★ 5
Great shirt & my son loved it.
Size: X-Large, Color: Blue
bought it for my son and he loved it. In fact when I called him he was wearing the shirt said it fit him well, it looked great. It was comfortable. He loved the quality & the cut. The length was great and ask me where I got it so I sent him the link so he could buy more in other colors. He loves to golf and said this is a perfect shirt for that. Plus the price was right.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 9, 2026
★★★★★ 5
sizing runs a bit big but very comfortable, i love these and ordered multiple colors
Size: X-Small, Color: Black
Initially, i ordered a small and an X small based on reviews here. Glad i did. I opened the x-small first and it fit perfectly. Returned the other one unopened. Sleeves fit my arms well. Collar stands up well. Shirt has sufficient length to tuck in too. Not super long though if you want to untuck with jeans.
I'm 5'6 140#. I lift weights regularly and run. I'm right at 11.8-12.0% body fat. I typically wear a small in the amazon essentials slim fit t shirt. Those fit really well in size S. Check them out too if you have not yet. These polos XS fits equally well for my body type.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 27, 2026