Pay in installments of $40.55 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 31 - Aug 5
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Watergevulde Bokszak – Bokszak – Punching Bag – Trainingszak – Kickbokszak – Lekvrij Ontwerp – Metalen Ophangketting & VulbuisWatergevulde Bokszak Duurzaam, Veilig en Praktisch Wil jij thuis of in de sportschool effectief trainen met een bokszak die niet alleen stevig is, maar ook makkelijk in gebruik? Deze watergevulde bokszak is een slimme oplossing voor iedereen die kracht en conditietraining wil combineren zonder gedoe. In plaats van traditionele zand of vezelvulling gebruik je simpel water, waardoor de zak licht is om te verplaatsen, maar stevig genoeg voor intensieve
Watergevulde Bokszak – Duurzaam, Veilig en Praktisch
Wil jij thuis of in de sportschool effectief trainen met een bokszak die niet alleen stevig is, maar ook makkelijk in gebruik? Deze watergevulde bokszak is een slimme oplossing voor iedereen die kracht- en conditietraining wil combineren zonder gedoe. In plaats van traditionele zand- of vezelvulling gebruik je simpel water, waardoor de zak licht is om te verplaatsen, maar stevig genoeg voor intensieve stoten en trappen.
Waarom kiezen voor deze watergevulde bokszak?
- Eenvoudig op te vullen en lekvrij: De geïntegreerde vulbuis maakt het vullen met water snel en schoon, terwijl het lekvrije ontwerp voorkomt dat er water ontsnapt tijdens je training.
- Stevige metalen ophangketting: Deze bokszak hang je eenvoudig op dankzij de duurzame metalen ketting. Zo blijft de zak stabiel hangen, zelfs tijdens intensief gebruik.
- Comfortabel en veilig materiaal: De buitenkant is gemaakt van robuuste, waterbestendige stof die zowel slijtvast als zacht aanvoelt. Hierdoor behoud je controle over iedere slag zonder je handen te verwonden.
- Variabele weerstand door waterniveau: Door te spelen met de hoeveelheid water bepaal je zelf hoe zwaar en stevig de zak voelt. Dit maakt het geschikt voor zowel beginners als gevorderden.
- Compact en gemakkelijk te verplaatsen: Wanneer de zak leeg is, neemt hij weinig ruimte in beslag en til je hem moeiteloos op. Ideaal als je af en toe wilt wisselen van trainingsplek.
Perfect voor jouw trainingsroutine
Of je nu boksen, kickboksen, MMA of algemene krachttraining beoefent, deze watergevulde bokszak helpt je je techniek en uithoudingsvermogen te verbeteren. Dankzij de stabiele ophanging en het dempende water kan je veilig en effectief oefenen zonder harde terugslag. Thuis, in de garage of zelfs buiten – waar jij wilt.
Belangrijke specificaties
- Materialen: waterdichte buitenhoes, stevig kunststof vulbuis, metalen ketting
- Vulling: water (zelf te vullen)
- Afmetingen: geschikt voor standaard trainingshoogtes en -intensiteiten
- Gewicht: variabel afhankelijk van waterniveau
- Inclusief: metalen ophangketting en vulbuis voor gemakkelijk vullen
Met deze watergevulde bokszak heb je een flexibele en betrouwbare trainingspartner die jouw workout naar een hoger niveau tilt.
Ben jij klaar om kracht en precisie te trainen met een bokszak die meedenkt met jouw wensen? Probeer deze bokszak vandaag nog uit en ervaar het gemak en comfort tijdens iedere training!
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.0 ★★★★★
Based on 8 reviews
Sort
Product Reviews
★★★★★ 5
Wish they came with instructions...
They are cheap and work great. They plug right into my Pioneer vsx521 receiver and my Paradigm Atom monitor speakers.
I wish they came with instructions, because it took me about 10 minutes to realize the bottom part unscrews in addition to the top part.
Here are my instructions for installation:
1) Unscrew the bottom part of this connector (the thin metal underneath the red/black ring).
2) Make sure the Banana Plug (which may be loosely screwed into the top part of the connector) is fully tightened down
3) Strip your wire tips to 3/8 of an inch (or just slightly under)
4) Run the first newly stripped wire end through the bottom part you removed in step 1, such that the stripped end of the wire is entering through the flat end and exiting through the smaller threaded end.
5) Leave about 1/8 to 3/16 of an inch of stripped wire hanging past the exit hole.
6) As evenly spaced as possible, bend the over-hanging wire strands over the exit hole (all around it, like a hat). If done properly, the wire should not fall out if you give it a VERY GENTLE tug.
7) Screw the top metal part (with the actual banana plug) back onto the bottom part. It may be difficult if your stripped wire is hanging too low. I've used a pair of pliers to grip the bottom part of the connector while I twist the banana plug side with my hand.
If done correctly, you should be able to put a lot of tension between the wire and connector without removing/damaging it.
UPDATE:
I just recently helped my dad install his 5.1 system without these... it sucked... This item (5 pairs of them in this case) and a good wire stripper can save you alot of pain (both physical and mental). The connectors on the back of his receiver are the kind where bare wire comes in from the side and then the connectors screw down (with a banana plug hole in the center which is where this product would come into play). I felt like a surgeon trying to get a bare wire end into the little slot, and then holding it there while I tighten the connector which is almost impossible since they are so close together...
GET THESE!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 8, 2012
★★★★★ 1
'Monoprice' = Worst stereo banana plugs on T-H-E market.
Size: 5 Pack, Pattern Name: Banana Plugs
The absolute WORST in stereo banana plugs - HANDS DOWN. After installing stereos and components for over 30 years, I'd say I'm experienced. These banana plugs fail at EVERY part of the design. Allow me to explain...
1) Starting with the tips, they are loose off the bat and fit LOOSELY in either the stereo input studs or speaker input studs by their 'girth'. They do not firmly seat in any plug and for this setup, I'm using a nearly $2K setup all together. They 'rock' back and forth (when inserted) and thus create a non-permanent connection, again, seriously making these utter junk. I've seen some items you can get by with over the years, but these aren't even rock bottom. They are unusable!
2) Next, the banana plugs themselves comes as three pieces. No non loosening o-ring seal but a plastic colored want-to-be imitation for positive and negative notation. Why do these stupid things come in three pieces? - I simply can't tell you why. I do know they serve no specific piece to solving the puzzle of installation so why do they come in three pieces...? My speculation is they are cheap china knockoffs.
3) The 'way' in which you normally install the trimmed wiring internally with the 'two-piece' design permits you to firmly CRIMP and hold the unsheathed wiring; but these do not. The overlap/overlay of the exposed wiring can only be about 2/16's of an inch thus not much to create a proper connection with. This single fact eliminates these plugs as even worthwhile component add ons; period. If you can't achieve a good ground/wiring connection, these are a defeated purpose...
4) Because of the design of these, they have no room to crimp and screw on the cable so your forced to nearly break your fingers in an attempt to get the unsheathed wire to overlay the internal threading and twist them on with all your might. This in effect breaks nearly every wire thread internally and then they breaks off inside. Absolute garbage.
These are total pieces of non-quality junk that did nothing but makes me waste 30 minutes on attempting to get them securely on and another 25 to locate my Amazon account, find this product in my order and ALARM anyone else from making the same mistake I made. Now, I find out I can't even get a return on these. Thanks Amazon. Thank you third party retailer. You just made me a very dissatisfied decade long customer.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 17, 2016
★★★★★ 5
Nice quality
Had to return due to our mistake but the mechanic said it was good quality. Ordered the correct size and worked great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 30, 2025
★★★★★ 5
Perfect fit
Worked great for a 1965 mercury thunderbolt 150hp
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 3, 2025
★★★★★ 5
MerCruiser Replacement Parts
OEM quality MerCruiser Alpha 1 Gen1 replacement part. Everything you need and some things you don't because it's a universal kit that works for several models.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 19, 2025